Add supplemental weather stripping around selected Model Y doors, pillars, hood, dashboard, and trunk areas.
This nine-piece adhesive seal kit is shaped for Tesla Model Y vehicles from 2020 through 2026, including the Model Y Juniper according to the current Amazon listing. The EPDM rubber strips are intended to supplement existing seals and may help reduce some wind intrusion, water entry, dust, or exterior noise when positioned and installed correctly.
Package contents stated by the listing
Two front-door strips
Two rear-door strips
Two B-pillar strips
One dashboard strip
One hood strip
One trunk strip
Ten adhesion-promoter packets
Key features
EPDM rubber: Selected for weather, heat, aging, and wear resistance.
Self-adhesive backing: Installs without drilling when applied to properly prepared surfaces.
Vehicle-shaped pieces: Preconfigured for the identified Model Y areas.
Broad model-year claim: Listed for Model Y vehicles from 2020–2026; confirm exact Juniper and trim fitment before purchasing.
Installation guidance: Clean and dry every mounting surface, test-fit each piece, apply the adhesion promoter only as directed, remove the backing, and press the strip firmly into position. Avoid installation in rain or on wet, dirty, waxed, or very cold surfaces.
Noise reduction varies with tire type, road surface, seal placement, existing weather stripping, and installation quality; a perfectly quiet cabin is not guaranteed. Do not cover factory drain paths, sensors, hinges, latches, airbags, wiring, or existing seals, and confirm that every door, hood, and trunk closes normally after installation. Review the current Amazon instructions before applying adhesive.